Overview

Silver Redhorse - Moxostoma anisurum

Also known as: Silver Mullet, White Nose Mullet, White Nose Redhorse, White Nose Sucker

The silver redhorse is found in the same general areas as the shorthead redhorse, Moxostoma macrolepidotum, but is not as wide ranging. It occurs from the Great Lakes northeast to about Quebec, Canada and south to southern Georgia, northern Alabama and Oklahoma. From there it extends to Lake Superior, northwestward to just across the border into Alberta, Canada. In the U.S. it does not extend very far west or east of the Great Lakes, except in Georgia and the Carolinas where it occurs all the way to the coast. It occurs northwest of the Great Lakes through the lower two-thirds of Lake Winnipeg to as far north as central Manitoba and Saskatchewan.

The silver redhorse does not have any teeth nor does it have dorsal spines. The single dorsal fin contains only soft rays and is located approximately in the middle of the back. The top edge of the dorsal fin is rounded (convex), whereas in the shorthead redhorse it is emarginate or concave. It is generally silvery in appearance, except for its bronze-toned or olive green back. The fins are either white or grayish or pale red, but they may appear bright red in netted fish because they hemorrhage easily. The nose is white and blunt.

This species can be found in medium to large rivers throughout its range as well as deep ponds and lakes that have sand substrate. Unlike their cousin, the carp, they are intolerant of pollution or very turbid waters so they are an indicator species for good water quality.  The average size for the silver redhorse is around 18-24 inches long and about 2-5 pounds but they have been known to reach up to 10 pounds.

Though not particularly sought after as a sport fish, it has some potential to become a very popular species in its range and is probably under utilized in this respect. The flesh is tasty and similar to that of the shorthead redhorse, but like the shorthead redhorse, it has many small bones. A bottom dwelling fish, this species can be taken by spin or fly tackle using lures or flies that can sink to the bottom such as jigs. Natural baits and dough balls are also effective baits.

Habitats

Outsides of Bends

When the river or stream curves, the faster water (which carries the food) moves to the outside of the bend, and fish look for food in these bends. If the outside of the bend also contains a rock or fallen tree (to slow down the food-carrying current), it’s an even better place to catch fish.

Inside Turns and Coves - The Opposite of a Point

An inside turn is a small inlet that cuts into the shore. If the water in the turn is shallow, you’ve got another break line and another great place to catch fish.

A cove is a larger version of an inside turn, with more shoreline, more shallows, more protection, and more fish. Smaller fish will patrol a cove for plant food and bait fish, and game fish may come early in the morning or late at night.

Rocks

Rocks are structure. They provide fish with shelter, cover, food and a possible place to mate. Remember, fish structure. If the rocks are in deeper water or on the edge of deeper water, they provide an even better place to fish. Just avoid snagging your bait on the rocks.

Freshwater Lakes and Ponds

Lakes and ponds are great places for fish to live. They produce abundant plant food and offer plenty of cover for fish to hide. Shoreline structures like docks, logs, stumps, brush and rocks provide shelter, shade and protection for fish, which means that they also provide great fishing opportunities for the anxious angler. You can fish lakes and ponds from the shore or from a boat. You can, also, find fish in shallow or deep water, in open water or near natural or near man-made structures. In lakes, you can catch freshwater fish like largemouth and smallmouth bass, pike, pickerel, perch, panfish, trout, and even salmon. Get to know your lake’s structure. Points, inlets, holes, sunken islands, dams, submerged objects (manmade or natural), reeds and weeds are all considered structure. You should always fish in and around structure. It’s a simple formula: 1.Structure creates shallows. 2. Shallows create plant growth. 3. Plant growth attracts baitfish. 4. Baitfish attract game fish.

Current Edges

A current edge is a place where natural or man-made objects slow the current. When the current slows, the food that travels with it also slows. So fish rest at current edges and wait for a nice, slow meal to come by. Current edges can be created by natural or man-made structures like bends, merging currents, drop-offs, rocks and islands.

Merging Currents - Feeder Brooks, Stream or Creek Mouths

Flowing water carries food. So when two bodies of flowing water meet, fish will find twice as much food. Plus, when currents collide, there’s a small area in the intersection where the water and food actually slow down, making merging currents an excellent place to catch fish.

Drop-Offs

When water flows over a drop-off, it slows down and sinks, taking the food it carries with it. A drop-off is a great feeding place because it has food, deeper water and it’s away from the current, allowing for a more relaxing dining experience for the fish.

Rock and Boulder Pockets

When flowing water hits rocks and boulders, it splits and goes around the obstruction, creating an area of calm water on the downstream side of the obstruction. Fish will rest, facing upstream, on the downstream side of a rock. These pockets are small, but a handy cast could land you a fish.

Undercuts

Undercuts are considered the perfect hiding spot on the river. They occur where the current has cut out a cave-like hole in earth or rock along the shore. If there’s a tree above the undercut, all the better. Undercuts provide protection from above-water predators and the sun. And easy access to deeper water for feeding or escape. The biggest, baddest river fish live in undercuts.

Dams and Falls

When water continually drops off a dam or falls, it creates a big hole or drop-off. Fish will sit at the bottom of these holes to get away from the current and to eat sinking food. Fish can get trapped in these holes if they are going upstream to find cooler water or to spawn.

Riparian Zones

Riparian zones are the middle strip of vegetation between the river and the flatter land beyond the shore. These zones serve as a natural biofilter to protect water from excessive sedimentation, polluted surface runoff and erosion. And they supply shelter, food and shade for fish and other aquatic animals. A thriving riparian zone is a sign of good water quality and good fishing.

Rivers and Streams

In a lake or pond, fish have to move around to find food. In a river or a stream, the food comes to them. So moving-water fish find hiding places and travel anywhere from a few feet to up to several hundred feet, several times a day to eat.

You have to decide if you’re going to fish where the fish are hiding or where the fish are feeding. Either way, you’ll have to learn about river and stream feeding and hiding structure.

Hiding structure include undercuts in the banks, eddies, sunken trees and overhanging trees and bushes: places that provide protection from the current and above-water predators.

Feeding places include the outside of bends, merging currents, drop-offs, feeder brooks and springs: places where the current slows down and food collects or sinks.

In general, fish found in moving water tend to be a little smaller than lake fish. But they’re fighters, strong from battling the currents.

Fishing Methods

Bait Casting

Bait casting is a style of fishing that relies on the weight of the lure to extend the line into the target area. Bait casting involves a revolving-spool reel (or “free spool”) mounted on the topside of the rod. Bait casting is definitely an acquired skill. Once you get the hang of the technique (check out the casting animation), you will be casting your lures right on target into the structures where fish are feeding and hanging out.

With bait casting, you can use larger lures (1/2 to 3/4 ) and cast them for longer distances. To get started, you’ll need a rod with good spring action, a good quality anti-backlash reel, 10–15 pound test line and a variety of specific bait-casting lures.

Drift Fishing

Drift fishing allows you to fish over a variety of habitats as your boat drifts with the currents or wind movement. You can drift fish on the bottom or change the depth with a bobber or float. Natural baits work very well but jigs, lures and scented artificial baits will produce good results, too. When drift fishing with multiple baits and rods, it is always a good idea to set out each bait at a different depth. This allows the angler to cover more of the water column.

Fly Fishing

With fly-fishing, various materials are used to design a very lightweight lure called a fly. A fly can serve as a ‘dry fly’ or ‘wet fly’. A dry fly will float on the water and mimic a floating insect and a wet fly will sink below the surface to mimic a swimming bait. It takes a little practice, but fly-fishing is a pure and exciting way to fish. Unlike other casting methods, fly-fishing can be thought of as a method of casting line rather than lure. Non-fly-fishing methods rely on a lure's weight to pull line from the reel during the forward motion of a cast. By design, a fly is too light to be cast on its own so it must follow the trajectory of the cast fly line, which is thicker and heavier so that it casts easier than lines used in other types of fishing (such as monofilament). The angler normally holds the fly rod in the dominant hand and manipulates the line with the other hand close to the reel, pulling line out in small increments as the energy in the line, generated from backward and forward motions, increases.

Spin Casting

We won’t say it’s foolproof, but spin casting is an ideal fishing method for beginning anglers. Spin-casting equipment is easier to use than bait casting. You can use it to cast both light and heavy lures without tangling or breaking your line. Basic equipment includes a 7-foot rod, a spinning reel and 6–10 pound test line for casting 1/16- to 3/4 ounce lures. You can use an open-face, closed-face or spin-cast reel for spin casting.

Still Fishing

Still fishing is a versatile way to go. You can do it from a pier, a bridge, an anchored boat or from shore. And you can still fish during most seasons and during any part of the day. Your equipment and the size of the hooks and bait you use depend on what kind of fish you’re after. Your best equipment for still fishing is patience. You have to wait for the fish to bite. A great method for still fishing is to use one rod with natural bait that will soak or sit on the bottom as well as a casting rod with an artificial bait or lure. While you’re letting your natural bait soak, you can keep occupied and cover more ground while taking casts with a lure.

Bait & Lures

Bread or Dough Balls

Bread and dough balls make for excellent baits for bottom feeding fish. The bread or dough leaves a nice scent trail in the water that can be detected by bottom dwelling fish suck as catfish and carp. Any bread or dough will work but if making your own dough, make sure the dough is nice and firm so that it will remain on the hook when submerged in water. When using a piece of bread, add a little bit of moisture to the bread by chewing on it or splashing a small amount of water over the piece. Shape the bread or dough into a compact round ball and bury your hook in the ball so that only the hook tip sticks out.

Cut Bait

Using fish cut into pieces attracts fish in a different way than whole, live bait or lures. Fish that are attracted to scent are more likely to hit on cut bait. You can use just about any baitfish to make cut bait as well as other fish species. Before using any fish as cut bait, always make sure the fish you plan on using is a legal species and meets the minimum size requirement, if there is a size limit on that species. All size and species regulations can be obtained at tackle shops or your state’s fishing law enforcement website.

Flies

Poppers and flies are small lures used with spincast and fly-fishing tackle. These baits are very good for pan fish and other fish that feed on the surface such as trout and bass. Poppers get their action from a cupped face carved or molded into the front of the lure body. Fly action is totally controlled by the angler.

Jigs

Jigs have weighted metal heads and a tail made of animal hair, soft plastic, feathers or rubber. Anglers sometimes add a minnow or piece of pork rind to the jig's hook. Jigs can be used to catch nearly every kind of freshwater fish

Minnows and Nightcrawlers

Basically, minnows are baby fish and a good all-around freshwater bait. They're readily available from bait and tackle shops or you can catch your own if it's legal in your area. Minnows come in different sizes. Use larger 'shiners' for bass and pike fishing.

For cast and retrieve, trolling and drifting, hook the minnow vertically through both lips or through the tail.

For still fishing with a bobber, hook the minnow through the back just in front of the dorsal fin. Take care not to damage the spinal cord. The key is to keep the fish moving on its own.

Tricks and Tips for Minnows

For really good action, hook the minnow upside down on a light jig. It will struggle to regain an upright position

Store minnows in a minnow bucket using the same water from which they were bought or captured, and take care not to crowd them.

Worms are a good bait for nearly all freshwater fishing. You can find enough worms for fishing from a few shovels of dirt in your garden or from a shaded, damp area. Worms can also be purchased in fishing tackle stores and bait shops. For walleyes and bass use earthworms or night crawlers.

For pan fish, sunfish and trout use smaller manure worms. You can find them in cattle and horse pastures.

Trick and Tips for Worms

To prevent smaller fish from nibbling the worm without biting down on the hook, you can use just a piece of the worm.

If you have small worms, thread the hook through the side of the worm at several places along its body. For bait-stealing fish such as sunfish, thread the worm on the hook until the hook is completely covered.